The bathroom leaked feces

Updated on Bathroom 2024-08-01
1 answers
  1. Anonymous users2024-01-24

    The sewage pipe interface fell off, and the property or community was reported to them for disposal.

Related questions
2 answers2024-08-01

If it is a toilet, it may be that the toilet was not sealed properly when it was installed, and you can see if the glass glue at the bottom of the toilet is degummed? Another possibility is that the sewage pipe is damaged, you can check whether your wall or ceiling often has water stains seeping, if you exclude the above two possibilities, then only your drainage pipe is connected to the sewage pipe, and there is no installation of the water trap, to completely solve this problem is more troublesome, the installation of odor-proof floor drain will affect the speed of drainage, it is best to reinstall the drainage pipe and add the water trap, although it is troublesome, but it can be done once and for all. (Actually, you can check the root cause by getting close to some of the places that might be smelly.)

1 answers2024-08-01

1. The main components of the gas emitted in all bathrooms are hydrogen sulfide, ammonia, methyl mercaptan, indole, methane, ethane, etc. Peppermint oil, camphor oil, eucalyptus leaf oil, clove oil, cinnamon bark oil, etc. in the cooling oil are all from natural plants and have a special fragrance. For example, peppermint oil has a mint aroma, eucalyptus oil smells like camphor, and cinnamon oil has a cinnamon fragrance, which can chemically react with odorous gases to eliminate odors, which is safer and more effective than chemically synthesized fragrances. >>>More

1 answers2024-08-01

This should be the reason why the sewer pipe bubbles under the action of the water flow, and the amount of large bubbles in the water flow will also be very large.

2 answers2024-08-01

"" to run. If you get lucky, you're going to get rich. Seek adoption.

2 answers2024-08-01

Before laying the bathroom floor, it needs to be waterproofed! There is a special waterproofing agent! After the treatment is dry, then release the water to test the waterproof effect, if there is immersion in the water, you need to do it again! Until you are satisfied!