-
Anonymous users2024-01-24Hello!
Remove the water pipe connected to the toilet and the angle valve first, see if your toilet is silicone installed or cement-installed, scrape the silicone installation with a wallpaper knife, and turn it up in one direction! For cement installation, use a flat screwdriver and hammer to chisel the gap between the toilet and the floor, and the strength is small to large, and where the cement is thick, it will be chiseled. When the toilet is loose from the floor, it can be turned up.
When installing it again, use an angle grinder to install a toothless saw blade and cut off the excess cement at the bottom of the toilet
-
Anonymous users2024-01-23Some toilets have nuts on the back, and some toilet seats can be pressed in the crutches, depending on which one you have.
-
Anonymous users2024-01-22This can be said to be professional, or it can be said that the general 、、、 you go to Tianfu Decoration Network, take a look, it seems that there are also relevant introductions... Good luck O(O
-
Anonymous users2024-01-21Toilets are cemented in the early days and recently cemented in the paste.
Don't try it yourself, you have to find a professional master to solve it.
First, if you want to quickly and conveniently remove the damping on the toilet seat, you must first understand its internal structure and dismantling methods >>>More
Is there two pillars at the end of the toilet seat, and there are two buttons on it, press it in, and then pull it out.
Insert a glass knife into any of the four corners of any board and pry it out. Or if you have a suction cup, you can suck it up and pull it down. Remember to pull down or pry, not up. >>>More
Panel furniture is divided into assembly and disassembly, the whole assembly can not be disassembled, at most is to remove the foot and drawer, door panel, the basic components of disassembly and assembly can be disassembled, panel furniture generally has the corresponding disassembly tools, such as Phillips screwdriver, wrench,. >>>More
Step 1: Find the screw cap, remove it with a live handler, and replace it with a new one. Generally, the position of the screw cap is not easy to find, some are in the light, and some are in the dark. >>>More