-
Anonymous users2024-01-24It may be that the lamp is not installed properly, or the contact is poor, depending on what kind of lamp it is.
-
Anonymous users2024-01-23Poor contact.
Ask an electrician to help you see that poor contact (indirect short circuit or open circuit) can easily induce fire, and deal with it as soon as possible.
1. The living room circuit breaker trips and stops the power supply. >>>More
The break should be correct. If you change to an incandescent lamp, the "prompt light" will be on, but the incandescent lamp will not be on, because the internal resistance of the "indicator lamp" is very large, and the voltage drop is also large, and the voltage applied to both ends of the incandescent lamp is low (not enough to light it). The glowing voltage of energy-saving lamps is relatively low (more than 100 volts), and the lamp can glow under high frequency and high voltage, but it does not reach the level of breakdown and is unstable, so it is a little bright but not normal brightness and unstable. >>>More
Bathrooms are usually divided into two categories, one is a wet environment, when the switch is generally set outside the door; The other is wet + dry, that is, the shower area is inside, and the outside is the toilet and washbasin setting area, and there is a partition between the two areas, at this time, the switch is generally set on the inside of the door.
What bath bomb, light warm or wind warm? Each bulb of the lamp is 275W, which is already the largest, and the lighting of the wind heating is not bright enough, so you can change the bulb with a higher power.
Find out if it's always off or if it's often off. If it is sometimes bright and sometimes not, it is estimated that the copper sheet of the lamp holder or the binding post is not in good contact. If you are inexperienced, don't do it yourself, find someone who understands to check it. After all, electrical work is dangerous.