-
Anonymous users2024-01-24If the floor tiles in the living room are not pasted properly, it is easy to have such a problem! It is often caused by improper construction. Let me introduce you to the following two solutions:
1. If the mortar is not loosened, only the tile falls off, the mortar on the back of the tile and the surrounding adhesion can be scraped clean, mixed with a little cement in 107 glue to form a paste, evenly coated with a thin layer on the back of the tile, and then the tile can be glued firmly.
2. If the mortar falls together with the tiles, first gently chisel some pits on the original foundation surface, and then re-inlay them with mortar mixed with 107 glue, or use cement, E-44 epoxy resin, acetone, ethylenediamine Chemical stores are available Press 5:3:2:
After mixing well in the ratio of 1, brush a layer on the foundation surface with a brush, and then press the peeling tiles until the mortar hardens.
It should be noted that if the tiles are only partially falling off, do not hit the mortar on the foundation surface to prevent the original solid tiles from being loosened. The tiles should be soaked in water for more than 2 hours before paving, so that the tiles can fully absorb water, and then take out the shade to dry or wipe the clear water; Check whether the plastering of the wall base meets the requirements, and the stolen goods and dust of the wall base must be removed.
I will share this problem with you here, it is worth noting that when decorating, you must ask a responsible master who is an expert, and if you have time, it is better to supervise it on site.
-
Anonymous users2024-01-23It can only be redone.
However, it is best to find out the reasons before redoing it, one is whether the ash and sand ratio is suitable or whether there is too much moisture or too dry when mixing, whether the unqualified cement is used and has no strength, and whether the other is done and the person is on the job to cause hollowing, etc.
The strength of the mortar can be checked immediately, and the result will be known when a brick is pried open. As for the early seasoning, this person knows best, just ask them. We generally call this material "material", that is, it can be formed when it is pinched in the hand, and it will be scattered when it is thrown on the ground.
It is estimated that it is caused by insufficient strength or too dry mixture, otherwise it will not be a large area.
There are many reasons for the hollowing of the floor tiles, which may be caused by the fact that the original ground has not been cleaned before being laid, or it may be caused by the eagerness of the Master to step on it after the construction is completed. The solution is as follows: >>>More
No, it won't. Cold death = freezing death, rabbits are trained by hares, and their ability to adapt to the outside world far exceeds that of humans. However, it should be given the right amount of food, otherwise it will starve to death.
Judging from the figure, there are two possible reasons for this problem: 1. There is leakage at the joint of the buried water pipe, and 2. The connection at the joint of the sewer pipe is not tight. For the former, you can check whether it is a leakage of the buried water pipe by doing a pressure test on the water pipe; In the case of the latter, as long as there are no traces of leakage downstairs, let's observe and deal with it first.
For similar questions, it is best to indicate the location you want to rent, so that everyone can provide more accurate answers.
You can wait for a while to observe and observe, and if nothing happens, leave it alone.