Hello. I d like to ask how to copy something from the furniture layer in a layout to another layer.

Furniture beauty, as the name suggests, is the repair and renovation of furniture. And furniture beauty is just a general term, which includes five technologies, including lacquer, marble, leather, ceramics, and glass. It's all about technology that lacks talent in the market. >>>More

Chronic prostatitis is more likely, you can try to use a large basin of hot water sitz bath for half an hour tonight to see if the symptoms have improved tomorrow, and if there is improvement, it can be confirmed that yes, no is not, you can also pay attention to it, urinate for more than one minute at a time, but once every two hours, and urinate more than eight times a day can be identified as prostate disease, and then check.

Tools: Socket sleeve three mm (borrow from a car tire repairer) socket wrench mainly uses a 0mm; 14mm to support 13mm dull wrench, 4 iron water pipe, about 00 bar 00mm; pipe wrenches; Hammer (Yueyue) To judge that the deceleration clutch is bad, to replace the new deceleration clutch, you first need to disassemble the deceleration clutch: (1) Use a screwdriver to tighten the screw of the control seat, and remove the control seat, pay attention to the fact that it should be hard-pulled and connected to the water level, and it is in the air pressure pipe on the washing machine surface; (2) Use a screwdriver to screw the bucket fixing ring, fasten the screws, and disassemble the bucket fixing ring; (3) Then use a screwdriver to rotate the wave wheel screw, remove the wave wheel, take the wave wheel core gasket, you can see the washing dewatering bucket surface fixing seat and its surface, the dewatering shaft nut is rotated with a special tool or wrench, and then take the deceleration clutch, the dehydration shaft cushion sleeve is removed, and the dehydration bucket is washed, and then the dewatering shaft gasket is taken (the piece is important to replace the clutch with a new one); 4) The washing machine is tilted forward so that it is placed facing down, and the structure of the washing machine can be seen, and the fastening screws are removed from the fixed frame with a sleeve or wrench, and then the V-belt is removed, and then the deceleration clutch is fastened with a sleeve or a wrench screw, and the fastening screw is removed from the deceleration clutch (Attached: >>>More

It is recommended that the employee report to the arbitration commission for processing, apply for double wages and work-related injury compensation, otherwise, report to the labor bureau for resolution.

First of all, the cost of making furniture should be calculated clearly, and how much cost was spent on making which piece of furniture, this should be remembered. >>>More