There is no washing machine faucet reserved in the bathroom, how to install a fully automatic washin

1.A connecting tube for the washing machine.

2.It's just that the right end of the pipe is stuck in the faucet.

3.Faucets are best bought stainless steel, which are not prone to rust.

Extended Genus Information:

Maintenance lubrication. In order to make the washing machine run normally and easily for a long time, it is necessary to carry out correct lubrication and maintenance on time, the main places that need to be lubricated are bearings and gears, and the bearings need to be injected with L-TSA22 anti-rust and anti-oxidation lubricating oil with good wear resistance and oxidation stability through the oil injection hole, and generally refueled once every 2-3 years, if the general mechanical oil is used, it needs to be refueled once a year.

The gears should be lubricated with No. 2 extreme pressure lithium grease with good adhesion, or zinc dialkyl dithiophosphate with good oiliness with 1% mass content, or MoS2 with 3% mass content and L-CKC100 medium extreme pressure anti-wear gear oil for lubrication. The bearings and gears of the dryer should be added with L-AN15 and L-AN68 lubricating oil with good oxidation, anti-rust and anti-wear properties every year or half a year. If a sealed rolling bearing is used, it should be sealed by the bearing factory with a service life of more than 1000 hours, polyurea-based thickened refined petroleum lubricating oil, and No. 2 grease with anti-rust and antioxidant added.

After closing the main valve of the water pipe, remove this angle valve and install a 3-way, so that you can install the angle valve and the faucet for washing machines.

Basically agree with the second floor, come and remove the angle source valve, buy a two-end cable bai joint, a tee, a du head screwed on the zhi wall, and one end.

Connect the tee dao, the other end of the tee is connected with the angle valve, the middle of the tee is connected with a 4-point pipe, both ends must be threaded, the length of your washing machine height, and then the elbow of 90 degrees, and then the washing machine faucet. If you consider the strength and the faucet cannot be fixed, the tube should be shorter.

Find someone who does hydro, and he knows how to install a tee.

Only installed under the washbox, what pieces are needed and how to be safe?

As you have already said, there is no water outlet reserved for installing the washing machine, so you can only put the washing machine there at will to see if there is a moving water pipe that can be connected to the water inlet!

Install a three-way water distribution pipe at the water inlet switch below the sink, one end to the sink and the other end to the washing machine connecting pipe.

There must be a faucet in the bathroom. It can be used by connecting a water pipe from a faucet.

There is no need to install a washing machine faucet in the bathroom, so you can install a new one.