The family installed a new wireless optical cat in the living room, and later the master said that t

Updated on Living room 2024-08-24
3 answers
  1. Anonymous users2024-01-24

    Yes, but it doesn't work at all. All you need to do is change the wireless router to a high-powered one.

  2. Anonymous users2024-01-23

    First of all, it is not recommended to have more than two routes in the home (the fewer wireless devices in the home, the better, especially if there are pregnant women); Secondly, if the area of the home is more than 200 square meters or a villa, it is recommended to place the route on the ceiling in the middle of the house, and see clearly, "ceiling". If you don't have wiring, consider being in the middle of the house as much as possible. The method you said above can be implemented, but it must be the same model of route, as long as the name and password are the same, it will be automatically connected, no need to manually.

    Finally, be sure not to manually adjust the transmit power of the wireless router unless you want to turn your home into an oversized microwave oven.

  3. Anonymous users2024-01-22

    You can install an AP router. Connect directly to the LAN cable jack in the room. This way you will have an extra Wi-Fi in your room. Change the wireless password of the AP router through a notebook, and you can do it.

    Now the number of terminals in telecommunications is four, which is generally not checked, and I can sometimes reach 6-7 Internet terminals at home now.

Related questions
1 answers2024-08-24

The IP segment of the wireless route should be distinguished from the IP segment of the optical modem, and it is estimated that this IP conflict is caused.

6 answers2024-08-24

The relationship between the routers and the two corners have a large range.

3 answers2024-08-24

Your home wireless router will automatically dial up to connect to your broadband generation, go online, as soon as your computer is turned on, the computer will automatically connect to your wireless router, and then you can go online, no need to dial up!

3 answers2024-08-24

Buy the right power cat. Plug one into the router and one in the desktop socket. Transmission network via wires. No network cable is required. Where there is electricity, there is a network.

1 answers2024-08-24

Hello: The source of the mode you take is the mode of cat + router + router + computer. The details are as follows. >>>More