The home is Unicom s 1 trillion network, equipped with wireless, in the living room, the signal is v

Updated on Living room 2024-08-06
6 answers
  1. Anonymous users2024-01-24

    The relationship between the routers and the two corners have a large range.

  2. Anonymous users2024-01-23

    It's not just the speed of the internet, it's also the router. Generally, the effective distance of wireless routers is within 10 meters, and the signal penetration ability of the almost router is very weak, and the effective distance cannot be reached, and the effect of the partition wall is even worse. It's also possible that your house is too big and your bedroom is too far away from the source.

  3. Anonymous users2024-01-22

    It's the signal that is occluded.

  4. Anonymous users2024-01-21

    You can switch to a more powerful wireless router (with 2 antennas or 3) and you're good to go.

  5. Anonymous users2024-01-20

    The router is too bad to penetrate the wall, why is the router so bad.

  6. Anonymous users2024-01-19

    It's too far away, and the level is not very high、。。

Related questions
3 answers2024-08-06

Your bandwidth is 30Mbps, which translates to 30 8 for a computer. The speed was ok. You can try a wireless router with good stability.

4 answers2024-08-06

Plug the router into the master bedroom and set up autodialing.

1 answers2024-08-06

Are the cable cables in the bedroom and living room connected to the router? Look at your description, the computer dial-up Internet access is directly connected to the home network cable, right? In this way, only one computer network cable can be connected to the optical modem at the same time, and the Internet access through the router does not need to dial in the computer.

3 answers2024-08-06

Your home router can be used in the study, can not be used after changing to the living room, indicating that there is no problem with the broadband network, you can not access the Internet, it is recommended to check whether there is a problem with the router line access, you can try to dial up on the phone, if it is still not able to be used normally after self-service troubleshooting, it is recommended that you contact the local manual customer service to assist in checking.

1 answers2024-08-06

Hello, first of all, thank you for your support to China Telecom. I hope the following can help you, remove the router and connect the network directly through the cat to reach the contract rate, indicating that there is no problem with the broadband, at this time it should be a problem with the wireless router, please restore the router to factory value test, if it still can't reach the contract rate, please replace the router test. >>>More