What should I do if the bathroom has been tiled but there is still a small amount of water seepage?

Water leakage from the waterproof layer generally manifests itself in many cases. If the ground waterproofing is not done well, it may lead to water stringing at the door, blister floor, anti-water wall, leakage and mildew after water spraying the wall, and leakage downstairs along the gap of the pipe floor. In this case, the waterproof layer leaks water, and there are generally more leakage points downstairs.

Solution: waterproof layer leakage can be solved without planing bricks to do waterproofing, waterproof company provides bathroom tile surface leakage water repair three customer products, including penetrating waterproofing agent, caulking waterproof paste, plastic steel mud, three materials are used together to do waterproofing on the surface of the tile, and easily solve all the problems of waterproof layer leakage.

If there is a problem with the waterproof layer of the ground, you need to shovel off the floor tiles, find the waterproof layer that has the problem, and then seal it with a plugging treasure or a waterproof strip, and then carry out waterproof construction.

If the flow rate at this location is large, then the water level of the backfill layer in the bathroom is already very high, so the first thing to do is to find a plumber worker to bring an instrument to do the pressure test of the inlet pipe, if the pressure loss is to indicate that the inlet pipe is leaking, and it needs to be repaired accordingly. If the inlet pipe is fine, then consider looking at other causes based on the flow rate and drip rate. It is recommended that the bathroom at home be stopped for a few days and observe the change in the drip flow downstairs.

In addition, the state of downstairs also indicates that the surrounding closure of the developer's embedded drainage pipe is not dense enough, and you can find the property to negotiate and solve it.

The water pipe can be replaced for leaking water from the inlet pipe, and the original water pipe can be discarded and the water pipe can be reconnected, that is, the open pipe can be walked. Leaking sewer pipes need to be replaced after planing bricks, and then waterproofed and re-used, or not using leaking sewer pipes. Or casing, use a thin pipe to cover the leaking sewer pipe, and let the water go through the inner channel of the casing.

The middle part of the original pipe and the new pipe needs to be closed.

For the safety pipe on the ground, hot and cold water pipe leakage, you should first plane the floor tile, find the joint of the water pipe, seal the treatment, if the water pipe itself cracks, need to replace the water pipe, after the treatment of the water pipe to re-bury, repair the waterproof layer within the range, restore the floor tile.

Water pipe leakage: If the water pipe is leaking, you need to cut the wall tiles, then find the joint part of the water pipe, check whether the partition water pipe is leaking, find the leakage point, replace the water pipe or interface, and finally lay the wall, re-do the waterproofing, and restore the tile surface.

Inlet pipe leakage: The method of judging water leakage from the inlet pipe is that after the bathroom is closed for water ingress, the downstairs dripping stops. Open the bathroom to get water, and the dripping downstairs continues, and the drip frequency does not change.

Such leakage is the phenomenon of leakage in the inlet pipe. The specific method of determination is measured by the plumber pressure. It is possible to determine which broken pipe is leaking water.

The way to judge the leakage of water from the sewer pipe is to flush the water into the drain, hand basin, toilet and other sewer pipes, and do not pour water on the ground. Flush for 1 hour and observe the leakage phenomenon downstairs. The frequency of water leakage is accelerated and aggravated, and it can be judged as leakage water from the sewer pipe.