The balcony is converted into a bathroom, how do I deal with the waterproofing?

First of all, the ground treatment of the bathroom should be leveled, and then the waterproof treatment should be done, so that the waterproof coating can be effectively avoided and caused by water stain leakage, and the thickness of the brush should be the same at the joint, the gap between the wall and the ground contact between the bathroom and the gap between the upper and lower pipes and the ground contact is the most problematic place, so the waterproof coating in these places must be applied in place;

After the construction of waterproof treatment in the bathroom is completed, a waterproof test should be carried out to block all the sewers of the sanitary napkins, and then fill the toilet with a certain amount of water, and wait until 24 hours later, and then check to see if there is any water leakage. Note that this step is very important, it is the key to ensure the quality of the toilet waterproofing project.

Precautions for waterproof treatment of toilets:

1. In the general waterproof treatment, the height of the bathroom wall should be 35 cm high;

2. The wall close to the shower position should be waterproofed;

3. After the waterproof project is completed, the anti-water test must be done.

This is "directly on the original floor tile waterproofing, and then paste the floor tile", this method is the simplest and most economical.

But when doing waterproofing, it must be in accordance with the specifications, and it must not be sloppy at all.

In this case, the waterproofing must be done well, especially around the nozzle and around the foot of the wall. Don't be greedy for cheap materials, it is recommended that you use environmentally friendly and highly elastic JS waterproof latex.