-
Anonymous users2024-01-24Tile hollowing, you may wish to use the following methods to repair:
1. If the mortar is not loosened, only the tile hollow drum falls off, the mortar adhered to the back of the tile and the surrounding area can be scraped clean, mixed with a little cement in 107 glue into a paste, evenly coated with a thin layer on the back of the tile, and then pressed the tile to stick firmly.
2. If the mortar falls together with the tiles, first gently chisel some pits on the original foundation surface, and then re-inlay them with mortar mixed with 107 glue, or use cement, E-44 epoxy resin, acetone, and ethylenediamine to re-enter the store according to 5:3:2:
After mixing well in the ratio of 1, brush a layer on the foundation surface with a brush, and then press the peeling tiles until the mortar hardens.
Ways to prevent tile hollowing:
1. The cement slurry bonding layer is required to be evenly brushed, and the brushing time should not be too long, so as to prevent the air from drying and hardening, resulting in the separation of the surface layer and the base layer, resulting in bulging.
2. Mix mortar strictly according to the ratio, can not add water arbitrarily, mortar should be dry and hard, and the general thickness should be controlled at 2-3 cm.
3. When paving the floor tiles, the floating dust on the back should be cleaned and watered to ensure that they are well bonded.
4. When paving the floor tiles, press the four corners at the same time to make them contact with the mortar parallel to the mortar, and 2-3 cm higher than the pull line, and then hit with a wooden hammer or rubber hammer, and level the face with a level. After laying a piece, it is paved sequentially to the sides or in the backward direction. If it is found that there is a phenomenon of sagging, the tile should be lifted up, flattened with mortar and then paved.
Generally speaking, it is better not to stick, because if the floor is high, the balcony is often exposed to the sun, and then the heat expands and shrinks, in case it falls, it will be troublesome.
1. All beige or beige is good, the living room is pasted with marble, the price level is very different, the price ranges from dozens of yuan to hundreds of yuan, and the specifications are 80*80
It can be pasted, but it is used for embellishment, and it must not be pasted in a large area, which will be slag.
Bricks that are usually veneered with a special treatment or treatment (e.g., beautifying, easy to clean, or resistant to weathering) on one side. Answer. >>>More
[Enter the area and get a free decoration quote].
Due to the rapid development of industry, from the simple decoration materials in the past to the present decoration materials are varied, such as the decoration of the living room wall there are many kinds, the previous brush is putty powder, now you can use color paint, spar, etc., now there are many people choose the living room wall tiles, so what are the pros and cons of the living room wall tiles? >>>More