-
Anonymous users2024-01-24Positions can be swapped on the condition that your fiber optic cable can be pulled to where you are going.
-
Anonymous users2024-01-23You don't need to swap, just connect the wireless router to the cat.
-
Anonymous users2024-01-22My house is installed in the network cable jack.
Line router, the whole house has internet.
You don't need to reset the settings, just put the router to the optical modem and plug in the cable. If the signal is still not good, it is recommended to change to a router with higher power.
Low signal: 1Maybe the location of your desktop is not very good, and the desktop needs to pass through the wall to receive the wireless signal, especially the concrete (load-bearing wall), and the signal attenuation is very serious; >>>More
There is also a wireless router in the living room, and the bridge with the study is on the line.
Yes, there is a network cable between the cat and the router, extend it and grow it into your room, you can also change to a high-power router, now there are 200MW, two antennas, three antennas, the effect will be a little stronger,
Is that little box a separator? If so, move the cat and the invalid router directly to the living room, plug the network cable into the hole of the MODEM, and the rest can be changed. If it's not a separator, it's good to buy a separator, unplug the line plugged into the phone in the living room and plug it into the inlet port of the separator, the PHONE hole at the outlet port to answer the phone, and the MODEM hole to pick up the cat is good, it's very simple.