How to make the bathroom wall tile ash flat

Tile your own home, right, encourage. If you want to flatten the tiles, the key is to first make the foundation flat, make vertical lines up and down, make horizontal lines horizontally, and then make the wall as smooth as possible according to the pay-off line. After leveling, dry for a period of time at the beginning of the paste, so that it is easy to do a lot, when pasting the tile upwards put more water, put less cement below, the thickness of about 1-2 cm, the cement around it should be hung at an angle of 45 degrees or less, this is done in order to let the cement expand in the direction of the ground when pasting, the first time the tile is pasted will not be flat, the cement may be too or less, after viewing, take it down and trim the cement and then paste, the rubber hammer knocks on the four sides and corners to find the level, and the horizontal line is done horizontally, and the tile is attached to the horizontal line, That's generally fine.

For novices, it is recommended to find a small wall, paste it as a whole, and paste it again after taking it down, you can basically find the feeling, and you must take it down and dispose of the cement on the tile within 30 minutes, otherwise you may not be able to take it off, or cause the tile to crack. I'm a designer, but I also use tiles, which is fun.

Scrape it with a ruler and it will be flat, of course, this requires a certain amount of technology, and the general one is either more or less.