-
Anonymous users2024-01-24It can be repaired and polished by bonding or spraying.
-
Anonymous users2024-01-23It seems that it has only been replaced.
If the adjusting locking screw is loose and still can't be pulled, tighten the screws of the pressing plate at the bottom, so that the pressing plate is close to the guide rail, but do not press it. >>>More
The platen is stuck in the rails. If the tailstock fastening screw is still loose, see off the screw, take out the pressure plate, and replace the screw.
I don't know what you're trying to say, but I know that the tailstock is a tailstock on the rail, and the tailstock has a tip or a drill bit on it, and I hope it can help you.
Most ordinary lathes are manually drilled, and some models can be automatically drilled by driving the tailstock with a large pallet. A stepper motor is installed on the original rocker to achieve automatic feeding, and the tailstock of heavy machine tools can be automatically fed. Shenyang No. 1 Machine Tool Factory CA6140 horizontal lathe tailstock feed automation transformation, transformation parameters: >>>More
1. All 1, the most commonly used is to install a drill bit on the tailstock to drill holes on the lathe, and can quickly locate and tighten the parts when processing long shaft parts. >>>More