-
Anonymous users2024-01-24Check for yourself whether the water balloon touches the water tank wall and causes water to enter the plug seal, if so, tighten the water balloon, if not, then change the water balloon! It is recommended to find a master to take a look first!
-
Anonymous users2024-01-23There was no water on the top of the toilet, and it was there in a few minutes.
-
Anonymous users2024-01-22It's broken or blocked.
-
Anonymous users2024-01-21Check it out to see what's wrong.
There is a ball in the back cover of the flush toilet When the water is full, the ball will float The button is in a pop-up state When you press the button, the water will be released and the ball will go down Then it will be filled with water like a faucet The water will float up when it reaches a certain position The button will also pop up Depending on your situation, it is estimated that the water pressure is not enough to inject water or where it is blocked and cannot put water or the ball is stuck.
Summary. Please wait patiently for a few minutes, we are sorting it out, and we will answer you immediately, and please do not end the consultation. >>>More
The one that pressed down was actually a mechanical device. >>>More
Check the main valve for tap water first, and then open the lid of the water tank to check the upper and lower water, it is possible that the drain of the toilet has blocked the foreign object. See if the piston can be plugged, if you can't plug the water tank, it will leak, and if the water tank is not satisfied, the switch will not reach the water. It is also possible that the plug of the plugging tank is broken, or the connection with the button is loose, which will lead to the phenomenon of no water.
If the button pie can't be pressed, it is generally stuck between the side rubber of the button and the hole in the water tank cover. Just set it up and add some wax. >>>More