The masters who understand the waterproof and leakage repair technology of the roof bathroom came in

Absolutely not, it won't take long to get an effect, construction.

Scheme:1Raw material: Hefeng JE-I waterproof adhesive.

2.within the construction steps.

1. Mix the cement and sand evenly, and then add JE- and water.

2. Press"JE- cement silt sand water = 1 6 13 appropriate amount of water (about 2)."Stir into a waterproof mortar, pay attention to the mixing to be even.

4. Use qualified cement above general silicon, and the sand is medium and fine sand, and the mud content is less than 3%.

5. The amount should not be too much at one time, and the stirred materials should be used up within 45 minutes. Stirring must be even.

6. Proper maintenance after construction, closed water test can be carried out after 24 hours, and no leakage is qualified after 48 hours, and can be delivered.

7. The amount in structural waterproof concrete is 5% of the weight of cement.

8. The construction temperature is more than 5.

1.Construction raw material: JE-polymer waterproofing mortar.

2.Construction plan:

1. Clean up the construction surface and sweep it with water until it is slightly wet.

2. Mix the two components of the product and stir evenly for later use, do not add water.

3. Use a "batch spoon" or "brush" to evenly coat the glue on the treated construction surface.

4. More than two layers must be painted, and each construction interval should be done for the second time after the last dry (non-sticky), and the average thickness can reach 2mm.

It's not practical, what can you use to stick if there is dust in the gaps?? Nowadays, toilets and toilets are generally waterproof made of polymers.

There are many ways, waterproof, moisture-proof, your kind is just leak-proof, this is very professional, not very clear.

It can be adopted because it helps others to be happy.

I know the waterproofing technology of the roof toilet and have been practicing it for many years.