-
Anonymous users2024-01-24Look at it will be serious, and the other area is not large, and the normal area is not large.
The whitish part of the paint may be due to the fact that the air temperature is too low, or the water of the press is not filtered when the air temperature is too low. It is recommended to go to the paint store to buy a bottle of anti-white water (about the same size as the drip bottle and not expensive) Wipe it with white gauze or a relatively fine white cloth, not too hard, wipe it lightly, and wait until it dries to see if the effect should be much better. Note that since it is not an insider's operation, it is best to wipe it if it is still white, wait for two or three minutes, dry and then wipe, after a few more times, the effect is much better, of course, there are some differences with the side of the spray paint, and it is not obvious to see normally.
-
Anonymous users2024-01-23The edge strips, especially the curved corners, are not firm when brushed with paint, and they will peel and crack after drying. I recommend using spray paint, which is available in hardware stores in all kinds of colors, like insecticides, and first use paper tape to cover the parts that do not need to be sprayed, and only leave the edge strips to spray.
-
Anonymous users2024-01-22If the area is not large, go buy a paint pen of the corresponding color, if the area is large, you can do it again after grinding off the color, and pay attention to the details when wiping the base color
Panel furniture is paint-free (paint-free). Moreover, the melamine paper on the surface after pressing and pasting is scratch-resistant, light-resistant, and generally acid-alkali resistant, etc., which will be stronger than paint. The edges of panel furniture are hot-pasted with PVC or paper edge banding
Panel furniture is paint-free (paint-free). And the surface has been pressed and pasted after the trimerization'AN paper is scratch resistant, light resistant, general acid and alkali resistance, etc., and its properties will be stronger than paint. The edges of panel furniture are made of PVC or paper edge banding. >>>More
We produce PVC pellets, and the products produced by this company in the industry are good, and they are worth collecting.
The whole decoration process can be divided into two stages: hard decoration and soft decoration, after the construction and main material installation is completed, it will enter the stage of soft decoration, at this time each owner can add their favorite items according to their personal preferences, so a series of soft decoration articles have been prepared. >>>More
The commonly used glue for edge banding of panel furniture is yellow glue (neoprene rubber), before gluing, it is necessary to paste masking paper to protect the edge of the board to avoid leakage and pollution, and then glue the board, and then glue the edge banding, and then glue it, and then trim it after drying n hours. >>>More