-
Anonymous users2024-01-24You look good upstairs because of the choice of plan B bathroom waterproof in fact, the main prevention is bathing, washing clothes and taking off the cloth and other water without fixed sewer pipes, according to the national standard The position of the bath should be waterproof at the right angle of the bath from the corner of the wall to extend outward, the lowest is 1M distance, the height is In addition to this area, the surrounding should be from the ground to the wall to the wall to the height of 40CM The toilet sewer pipe The waterproof layer should be brushed back to cause the top of the pipe to break the water.
The sewer pipes of the toilet and wash basin are all connected with the top surface of your downstairs bathroom If the waterproofing of the periphery of the pipe is not reversed, then the water can directly seep downstairs along the outer wall of the sewer pipe, causing water leakage, so it is necessary to brush the waterproof high and hold the water Cover the water and let the water flow down the drain The waterproof layer of the entire bathroom is an upside-down hat There are several outlets at the bottom of the hat In addition to the fixed sewer pipe, it is the floor drain There can be no other water outlet.
Don't you get it yet? What you want to do is not the drain of the toilet, but the water without the sewer pipe, and the section of the sewer pipe of your squatting according to the regulations, it cannot be level with the floor tiles or cement mortar, that is, the drain of the squatting squat must be 2 3 cm higher than the floor tiles, so that the drain of the toilet can be directly inserted into the sewer pipe, so as not to run out of the water If you do as you say, then it is possible that the water of the toilet will overflow and the bathroom will smell bad, now understand.
-
Anonymous users2024-01-23Be sure to use plan B, and you must turn the edge to the top of the original sewer, because you have a floor of nearly 3cm high bricks and no more waterproof than bricks. The walls of the shower area must also be at least meters high.
-
Anonymous users2024-01-22Plan A will definitely not work, the end of the waterproof layer should be facing upward, so that it is possible to "pocket" the water.
Just show it to the master bricklayer, they all understand, the bricklayer can directly inlay you on the ground when he is working. I checked the information for you, which can be used for your reference. This floor drain belongs to the latest double-closed anti-odor floor drain, the thickness is approximately, the size and size are similar to the ordinary floor drain, if there is a floor drain mouth normally reserved, let the bricklayer master inlay you into it. >>>More
Due to the type of toilet and there is a relatively safe orientation, home feng shui is introduced as follows: >>>More
To put it succinctly; For undercounter basins, the countertop is about 73 cm above the ground. The mouth of the basin on the table is about 73 cm above the ground. The depth of the marble table is generally 55 cm, and the width varies according to the local conditions.
Cause of water leakage:
The waterproof layer is divided into a horizontal waterproof layer and a vertical waterproof layer on the side, the horizontal waterproof layer leaks to the downstairs if there is a problem, and the vertical waterproof layer on the side leaks to your own home if there is a problem. Water leaking into the corner of the outside of your bathroom or the door of the bathroom is first sure that the vertical waterproof layer on the side is broken somewhere, otherwise no matter how much water can only come up from the tile surface. In fact, the damp marks we see in the corner of the bathroom or the door of the bathroom are not vertically leaked in the past, theoretically speaking, as long as the waterproof layer is damaged somewhere, the open water in the bathroom penetrates below the tile surface from the corner, tile surface and joints or any other possible place, and is concentrated in the mortar layer, then the mortar layer is equivalent to becoming a water layer, and then concentrated in the waterproof layer where the damage leaks downstairs. >>>More
Do waterproofing needs to be done on the surface of the water, dig excellent permeability crystalline waterproofing, you can do it yourself on the cement surface with a super permeable waterproof guard (if there are cracks and potholes on the cement surface, fill the complete with metin porcelain glue and then do waterproofing). >>>More