-
Anonymous users2024-01-24It is recommended that you go and buy floor wax.
The correct way to use floor wax is to clean the floor first.
After drying, apply the floor wax near the seams and rub it continuously by machine or hand to melt and soak into the seams.
The purpose of this is to prevent water vapor from entering the gaps of the plank, causing the board to get wet, deformed and bent.
-
Anonymous users2024-01-23Let's reload. The previous one may have bought a bad quality one.
It's been a few years, and it should be relatively stable. >>>More
This is deformation caused by the physical properties of wood. The biggest possibility is that it has shrunk. The cause of drying shrinkage is that the moisture content in the air is reduced, that is, it is too dry. >>>More
The joints of the solid wood floor do not need to be filled, as long as they are installed according to the normal lock. This gap is left to coordinate the normal expansion and contraction of the floor due to temperature or humidity.
If your home is on the first floor, it is better not to caulk to ventilate, the first maintenance should be within a week, and the new floor is not allowed to be ventilated in the sun.
Regardless of whether the joints of the solid wood floor or laminate solid wood floor bulge after soaking in water, there is no other remedy except to replace it (which can be replaced as a single piece). >>>More