The top of the tailstock of the CNC lathe is not tight, and the handle shakes the thimble a few time

Updated on Foot of the bed 2024-08-18
1 answers
  1. Anonymous users2024-01-24

    To replace the copper nut inside, this is a standard part, you can change it yourself.

Related questions
What should I do if the tailstock of the CNC lathe is not shaking tightly due to excessive force whe
2 answers2024-08-18

It could be that the four screws inside came out.

How to move the tailstock of the inclined bed CNC lathe
1 answers2024-08-18

There are two types of inclined bed CNC lathe tailstock available: hydraulic and manual. >>>More

What should I do if the tailstock of FANUC CNC lathe is retracted and overtraveled?
4 answers2024-08-18

You should be talking about soft limit overtravel, because before the hard limit should be the first soft limit. If the soft limit overtravel, you only need to use the hand wheel to swing back. If it is a hard limit overtravel, there is generally a hard limit release switch, press and hold to move back. >>>More

How to deal with the overtravel of the tailstock of the CNC lathe
2 answers2024-08-18

Move the middle carriage to any safe position and modify the parameters.

Is there a bearing in the tailstock of the 6132 CNC lathe
2 answers2024-08-18

There is a set of thrust ball bearings, generally in the back. Depending on the model of the lathe, the model of the thrust ball bearing of the tailstock will also be different.