-
Anonymous users2024-01-24It is important to tell you a few aspects:
1.Buy a jet siphon toilet and flush it on the spot.
2.There must be a self-cleaning glaze, the difference in future use, the use of self-cleaning glazed toilets can never be sold below 800, don't be cheap.
3.Check the water-saving certification, now a good toilet can use less than 4 liters of water under the condition of ensuring the flushing effect, don't believe the sales pitch to see is believing.
Toilets are recommended for Ausman toilets and gold medal toilets. In particular, Ausman's new upgrade button AS-1279 may wish to try it if the price is reasonable. It's great.
-
Anonymous users2024-01-23If you need to find meγγγ quality assurance.
1. Before the installation of the toilet, check whether there is sediment, debris and other blockages in the sewage pipeline, whether the installation surface is level 2, determine the sewage pipe and draw a cross line 3, determine the sewage outlet of the toilet and draw a cross line 4, determine the installation position at the bottom of the toilet with an electric drill and bury the expansion screw 5, install a special sealing ring (i.e., steamed wax orchid or rubber orchid) at the sewage outlet of the toilet or circle glass glue (putty) or cement slurry cement and sand ratio 1:3 6. The toilet crosshairs and the surface crosshairs are quasi-consistent, and the bottom of the toilet is circled, glass, glue (putty) or cement mortar, cement and sand ratio: 1:3, and the toilet installation should be kept horizontal; 7. Tighten the screws for the installation holes of the toilets; 8. Install and debug the water tank accessories, install and connect the water source, check whether the water inlet valve is inlet and sealed, check whether the drain valve and the installation position should be installed closely, whether the leakage check whether the button is closed, whether the chain is short, whether it is appropriate, whether the machine is jammed, check the leakage, install the water inlet valve filter device 9, If you find any differences in the trial process of adjusting the toilet, please refer to the toilet tank accessories to see the fault and treatment, check and deal with 10, the toilet installation should wait for the glass glue (putty) or cement slurry to solidify and discharge water, and use the curing room 24
Clause.
1. Preparation for the installation of the flush toilet Before installing a flush toilet, the following 5 preparations should be made: first, check the level of the ground where the toilet is installed; The second point is to check the sewage pipe of the toilet bowl and remove the debris in the sewage pipe; The third is to leave a distance of 2 to 3 mm above the ground at the sewer outlet; The fourth point is to check whether there is any leakage in the water pipe and debug and install the water tank accessories. Finally, it is necessary to test the sewage effect of the toilet, if the water is flushed very quickly, it means that the drainage is not smooth and there is a blockage. >>>More
Flush toilet installation size: The standard of toilet size is the pit distance, that is, the distance between the puddle and the wall, there are 200mm, 300mm, 400mm. Most people use a 300 mm spacing. >>>More
How do you unclog a flush toilet? Toilet blockage is generally a blockage at the toilet trap, and the best and easiest way is... >>>More
Toilets can be cleaned in several ways:
1. Vinegar descaling. >>>More