-
Anonymous users2024-01-24The floor of the bathroom is 50 mm lower than the floor of the other rooms, and in order to ensure the effect of water, the height of the concrete wall water is 120 mm high on the requirements of the room, but the door is not.
Decorative water pressure testing will not be a problem, but sewer fittings are made of cement, if you are not careful, leaks, but not easy to find. The new sewer water flow is smooth, but as time goes on, or there is a game of debris blocking, poor water, seepage, water remains under the mortar layer of kitchen floor tiles, waterproofing is done better, like a cauldron, for a while and a half outside can not see anything change.
But no matter how large the pot is filled with water, when the gap inside the pot is the door, where traces of water will be seen in the surrounding walls will be found climbing up the water to the scale.
Your question may be relevant, so you may want to pay attention to it.
-
Anonymous users2024-01-23Basically, it must not be visible to the naked eye to be suitable, otherwise it will affect the appearance. Depending on the size of your bathroom, about half a centimeter is more appropriate. Pure hand hitting, looking.
-
Anonymous users2024-01-22Generally, the slope of 3/1000 is about the same, according to the size of your bathroom.
Usually we refer to the slope in the decoration of the general family refers to the place where there is a floor drain, if there is no floor drain, it is not necessary to find the slope, especially in the kitchen, the ground is relatively dry, and there is no water flow to find the slope. The bathroom depends on how you decorate, if there is a floor drain, 2-3% to find a slope.
The inclination of the bathroom tiles is generally about 1 cm to 3 cm per meter. >>>More
Wouldn't it be enough to raise the track to balance? Add some ground height.
If there are pipes on the ground that need to be leveled, it is normal to raise so much. Under normal circumstances, it takes about five centimeters from waterproof to tile.
First, the bathroom needs to have an inclination angle in order to drain more effectively. There is no inclination angle on the floor of the bathroom, so you can knock off the cement layer of the floor tiles and re-lay the floor tiles to make the sewer inclination angle. >>>More