-
Anonymous users2024-01-24Whether your pipe is bent well or not, just cut the arc welding
-
Anonymous users2024-01-23There's that semi-circular stainless steel joint, and I've been doing stainless steel for a year.
-
Anonymous users2024-01-22The hospital beds are still home, and we use pipe benders to bend the hospital beds.
First the coarse gauze sand wheel, then the fine gauze sand wheel is polished, waxed and polished.
This is a small problem, the full welding to deform the master's craftsmanship is too poor, you let the master the welding rod to choose a good, and the stainless steel material is matching, and let the master use the angle grinder to make the two plates a slope of about 45 degrees, and then dock up to fill the weld, (of course, the master's craftsmanship is good) turn over and walk on the opposite side, it must become, and finally knock off the welding slag, grinding on 0k. (This stainless steel is definitely thin, not everyone can weld it).
1. The ceiling can not bear weight, and the clothes are very heavy, and must be fixed on the top of the wall (floor, beam, etc.), which is safe. >>>More
Get a set of colored things to check where there are cracks, where there is leakage, find the leakage point and weld it with low temperature method, because your stainless steel is relatively thin, flame temperature control is very, very critical when soldering with low temperature, solder is selected with low temperature WEWELDING88C welding wire with 88C-F flux welding, and welding with a high-power electric soldering iron can also be used.
Grinding and polishing to enhance the finish of the appearance. >>>More