-
Anonymous users2024-01-241. Caused by the parallel connection of the lighting switch and the exhaust switch;
2. In order to facilitate the needs of users, the general bath bomb will connect the exhaust switch and the lighting switch in parallel, so that the user can automatically turn on the exhaust when entering the bathroom and turn on the light, saving the user the cumbersome operation of opening the exhaust for the second time;
3. If the user needs to control the exhaust and lighting separately, you can disassemble the control switch wire box, and connect the live wire separately in the four switch inlet ports, and the four output ports are connected to the lighting, exhaust, bath bomb 1, and bath bomb 2 respectively
4. After separate control, the lighting, exhaust, medium temperature of the bath bomb, and high temperature of the bath bomb can be turned on separately. It is convenient for users to choose, but generally requires users to operate the switch more than once.
-
Anonymous users2024-01-23Reason 1: There is no slope when the hole is drilled from the inside out, or the slope is down.
2: The outer mouth should be provided with a protective cover (sold in the building materials market), and the installation can not be reversed.
3. The exhaust pipe is not installed in place and falls off (not extended to the outer wall protective cover).
4. The exhaust port is too wide and not treated properly, so that it is blown into the rain when it rains and winds.
-
Anonymous users2024-01-22It should be, the exhaust and the lamp left at that time are controlled by the same switch, please electrician, change it, put 2 switches, for reference.
You first check whether the switch wire is active, if not, it is the LED starter or light strip failure, it is best to find a professional acquaintance, pay attention to safety!
This phenomenon is because, the air in the kitchen is pumped away, and another air is needed to fill the vacancy, which is the air coming in from the adjacent bathroom, and the solution is to open the kitchen door when turning on the range hood, and let the air in other rooms come in
First of all, there must be a problem of short leakage, you should be on the line of your bathroom, find an electrician to check it in detail, and the second is that the leakage protection switch of your home has far exceeded the capacity of the floor and the whole building, so your home will not jump, according to the normal configuration should be your home jumped first.
Make a sandbag with cloth and press the floor drain on top. Or pour some water on the floor drain.
It may be that the sensitivity of the leakage protection is different between the two.