-
If the switch can be turned on normally, it proves that there is no problem with the switch, rule it out.
The segmented remote control switch can control the circuit normally, and there is no problem with the receiver, eliminate.
It is estimated that it is a problem with the relay on the circuit board, or a problem with electronic components similar to the relay.
If you still have questions, ask again!
-
How to solve it in the end, mine is the same as you, it can only be turned on by remote control.
-
Check the switch first to see if there is any problem.
Segmentation is much better than stepless dimming, stepless dimming is usually known as intelligent, but it is not easy to use, stepless dimming is more energy than segment dimming driver, and it is not recommended to use stepless dimming at present.
Problems in the design of the power supply may cause this phenomenon, and the slight brightness consumes almost no power, and the chance of affecting the life of the light strip is not large. However, this may indicate that there is something wrong with the switch or wiring, or that there is a small light on the switch. For example, the use of dual control switches, the ground wire leakage current is large. >>>More
The light strip is just an auxiliary If the ceiling is placed in the gap, the ceiling lamp is the main lamp in the living room.
>3£¬ÈledµÆµ
>4£¬½220V¼Ìµ >>>More
You first determine whether there is a problem with the switch, and if the switch is good, which is. LED light, which piece is faulty, or the controller inside is damaged, I hope my answer will be helpful to you.