Is it better to glue the toilet bowl with glass or white cement

Generally, the toilet leakage is only in the sewage pipe interface or water inlet and other positions, the bottom of the toilet will not leak, glass glue or white cement is only to fill the gap between the toilet and the ground, in order to achieve a beautiful decorative effect (in the past, white cement was used, and now glass glue is used).

If the glass glue is wiped away, revealing the gap between the toilet bowl and the floor, just buy some glass glue and put it back (preferably a white "porcelain white glue").

If the toilet leaks and needs to be removed for repair, as long as you use a wallpaper knife to cut deeply into the inside of the toilet, and cut off the glass glue under the toilet bowl to remove the toilet bowl, the wallpaper blade is relatively thin and will not damage the toilet.

It doesn't matter whether the glass glue on the back cover is there (whether it is glued or not) and whether it leaks or not.

Today's toilet installation is more reasonable and scientific than in the past. Glass glue (silicon copper) has good elasticity and firmness, so it is not afraid of general collisions, white cement will not work, the adhesion is not good, easy to crack, and the installation of the toilet is not stable at all.

In fact, there are two purposes for installing a toilet bowl with glass glue, one is to strengthen and stabilize, and the other is to look beautiful.

If the toilet does not collide with it, even if it is not glued, it will not fall, and it will not be used, but in real life, to prevent external forces from colliding with it, it must be protected by glue.

It should be noted that after beating the glass glue, you can't wipe it immediately, wait for it to be completely dry, and then dispose of it. The installer didn't seem to have much experience. However, there is no need to worry about anything, and it is generally fine to install at the nozzle.

When it is the worst, it is nothing more than the poor quality of the flange, which is also used.

Note: As long as it is the drain of the toilet bowl and the seat drain is 2-3 cm, there is no problem.

The worst thing to think is that if there is a problem, it will be reinstalled and will not cause damage to the toilet.

Now silicone is basically used (glass glue is also a kind of silica gel), and the putty used in the past is also very good.

Generally, white cement is not used, because the waterproofness of cement is not good.

The glass glue is good, it is soft, the white cement is not very brittle, if you accidentally touch it when you use it in the future, the white cement will crack, and the glass glue will not, but the glass glue can not be used immediately after being coated, at least 48 hours after solidification and then use.

In fact, if the toilet is installed well, there is no need for glass glue or white cement, if you feel uneasy, then play glass glue, in case the toilet is blocked, it is easy to remove it and dredge.