How high should the waterproof wall of the bathroom be? What materials are better?

The height of the waterproof wall of the bathroom: the shower area should be 180cm or to the top; The height of the wall in other positions should be more than 30cm.

Polymer cementitious waterproofing coatings are now commonly used in restrooms. This kind of waterproof material has the remarkable characteristics of simple construction, can be constructed on the wet base surface, non-toxic and harmless, long service life, reasonable price, etc., especially suitable for home decoration waterproof bathroom This area is small, there are many pipes through the wall, the ground is damp, and the bricks should be pasted on the waterproof layer and the waterproof decoration of the place on the wall.

Don't worry about the wall not being pasted with bricks, as long as the paste is in accordance with the correct construction instructions of the tiles, there are gaps between the tiles, and there will be no brick drops.

GENERALLY SPEAKING, THE SHOWER AREA IS 1800MM TO 2000MM, AND THE OTHER FLOOR AREAS ARE 400MM TO 500MM!

Waterproofing Generally, it is divided into flexible waterproofing and rigid waterproofing.

This prevents natural factors such as cracking over time!

Don't worry, you can go up any wall tiles.

Do not worry. After doing a good job of waterproofing, remember to test the water, and after getting good water, wait 24 hours to see if there is any water leakage! If there is, it will be repaired! Also, remember to do waterproofing, when you are sure to deal with the sewer pipe, do not let the waterproof glue into the pipe!

m, with JS polymer cementitious waterproof coating, environmentally friendly products.

Here's what happened.

If you use "acrylic" waterproof paint, this situation exists! But there are no problems with "polymer" (JS) waterproofing materials. Of course, you have to buy a more expensive JS waterproof material.

The market is basically less than 200 yuan is the enterprise standard, and the national standard has more than 200 yuan.

Height: It's not bad to brush rice for a few hundred dollars. It will be beneficial!

Generally 2M, stick the top by the bedroom, in order to prevent moisture.

Make meters on the wall of the shower, and the rest of the wall 30 cm from the ground can be fully brushed, and apply it with a special waterproof. Taijie from Yantai is very waterproof.

According to the training materials of "Waterproofers" prepared by the Department of Personnel Education of the Ministry of Construction, the content of the waterproof construction chapter of the bathroom: The fortification height generally requires the waterproof layer to be 250mm from the ground, the height of 500mm on the upper edge of the bathtub and 1500mm in the shower. Practice has proved that the waterproof height of the bathroom with shower area should be more than 1800mm in order to effectively prevent leakage.

Kitchen waterproofing is generally 30cm above the ground. Material: Waterproof coating is generally used, and coil material is rarely used.

There are a lot of water pipes on the kitchen and bathroom floors, and the membranes used for water pipes are prone to problems; The advantages of waterproof coating: it can easily penetrate into some invisible corners, and the construction is convenient. Waterproof paint you can choose from:

911 polyurethane paint for dry floors; K11 and JS cement-based flexible waterproof coatings for wet grounds, water-based coatings、、、 K11 dry mortar for wall moisture-proof、、、 Note: The construction must be careful and patient, and the main location: nozzle and yin corner position.

The materials I recommend: Guangdong Dapeng "Penglaite" K11 flexible coating 460 yuan set, Luban 911 polyurethane 480 yuan set.

The minimum meter of waterproofing in the bathroom, which is stipulated in the specification, is generally cement-based waterproofing, because the cement-based waterproof coating film is the most convenient for the wall tiles of the bathroom to paste.