How to make up for leakage in the shower room?

If you want to replenish water, of course, the cause of the water leakage is to judge it, if you want to replenish e68a8432313133353236313431303231363533313333653437, you need to use more professional tools, the following will introduce you to a complete set of methods, if you still can't do it, it is recommended to contact the manufacturer's master directly to deal with it.

Judge the cause of water leakage in the shower room: where is the leakage in the shower room, if the position of the water retaining strip leaks outside, you can buy some good quality transparent silicone and silicone gun, and then hit the winger on the inside of the retaining strip Silicone, but before gluing, you should scrape off all the original sealant to clean up the gaps, and pay attention to be sure to let it dry fully before embedding the new sealant into it.

If the floor leakage of the shower room has leaked to the downstairs residents, then this is caused by the bathroom is not waterproof, this problem is difficult to solve, only the original floor tiles are removed, let it do the second waterproofing, and then stick the floor tiles.

Common solutions:

1. Pay attention to the waterproof adhesive strip and water-retaining substrate of the shower room, whether the shower room leaks is very much because its adhesive strip is not whole, if there is a joint, we must pay attention to whether it is disconnected. Some low-cost shower rooms on the market have poor adhesive strip treatment, and some glass is even in direct contact with the stone base, causing the glass to break and leak easily.

Clause. Second, check whether the floor drain is smooth, if it is blocked, it needs to be dredged, otherwise the water will only get more and more serious.

Clause. 3. Carry out drainage groove treatment on the ground of the shower room, make drainage grooves around it, open the water line groove in the middle, and quickly introduce the water into the surrounding groove when it falls to the ground, even if it cannot be discharged, there will be no water blistering feet.

The above is the method and remedy for judging the leakage of the shower room, I hope it can help you, if you don't understand, please continue to point it out.

The shower room leaks du, which point of water leakage, is not the position of the water retaining strip to leak outside, if so, this is relatively simple, you can buy a better transparent silicone, and then buy a silicone gun; Then hit the winger on the inside of the water retaining strip with silicone;

If the shower room floor leaks to the downstairs people, this is caused by the waterproofing of the bathroom is not done, this can not be solved, only the original floor tiles are removed, let the waterproof be done twice, and then paste the floor tiles.

Wipe the water on the tiles, be sure to dry thoroughly, buy Corning silicone, and then make every exception, and then make sure that you don't use water for 24 hours, that should be fine.

You cut the original glue clean with a blade, and then hit it again with neutral transparent glass glue, which must be dry and cannot touch the water for 24 hours. No problems guaranteed.

I saw your picture, I can only use glass glue, you must not have done it well, you have to start from both sides of the door, the ground rotation must be dry, it should be no problem, try it.