-
Anonymous users2024-01-24Plain concrete masonry or structural reinforcement can be, the width is the same as the width of the wall, the height is like 200 as you said, and the masonry is built along the partition wall around the bathroom, if the concrete wall does not have this problem. This is a building waterproofing requirement, and has nothing to do with the structure.
-
Anonymous users2024-01-23That is, there is a 200-high upturn beam under the wall around the bathroom
-
Anonymous users2024-01-22Add 200 high concrete under the masonry, and the masonry concrete wall is thick
-
Anonymous users2024-01-21It's just to be an anti-beam, what's the problem?
This proves that the seal of the drain is broken, or the toilet drain is not aligned with the drain mouth, and the water is reversed when flushing, which can only be dismantled and reinstalled ,--
If there is no problem with the bathroom plumbing system, you can use --- cologne seam tape to treat all tile joints. It is completely transparent after drying. It works great!
It is necessary to remove the surface layer and re-do the waterproofing, with waterproof paint treatment, at least 250mm high on the wall, and 1800mm in the shower
In the bathroom, the lower part of the wall around the tube well and the yin corner of the ground should be coated with pure cement more than 200mm, and the coating thickness is the same as the thickness of the cement layer on the wall. It is generally 2 to 3 cm thick. >>>More
Dip a sponge mop in laundry detergent water and clean it twice. The dirt is floating ash and fumigation, which dissolves quickly once it is wet, and the plastic gusset is water resistant and easier to clean. >>>More