The exterior wall of the balcony is not painted with exterior wall paint, but there is a layer of ce

First look at whether the insulation layer uses galvanized mesh, if not, add a galvanized mesh, smooth it with a ruler-type waterproof and anti-crack mortar, and paste the tiles with a good wheel of tile adhesive.

Now the building is required to insulation, the material is indefinite, mainly extruded polystyrene board, do not smash off the insulation when inlaying bricks, this will produce a cold bridge, is not conducive to the firmness of the exterior wall bricks, and is not conducive to the balcony insulation, before pasting the exterior wall tiles, the polymer cement mortar is scraped on the insulation layer before pressing into the glass fiber mesh, and then the exterior wall tiles can be pasted. But just ask, does the property let you change the style of the façade?

Are you talking about the balcony on the first floor, or the balcony on each floor is tiled? In addition, the cement slurry of the insulation layer is full of steel wire mesh or glass fiber mesh. If it is a glass fiber mesh, you should re-hang the steel mesh and anchor it with an expansion bolt, wipe 8-12mm special insulation and anti-crack mortar, and then use tile adhesive to paste the brick.

If it is a high-rise building, tiling is not allowed.

Why do you have to paste tiles?,Do it well with thermal insulation and do it well.。。。

First look at whether the insulation layer uses galvanized mesh, if not, add a galvanized mesh, smooth it with waterproof and anti-crack mortar, and paste the tiles with a good tile adhesive.

There are only three ways to tile tiles:

1.The most sure way to increase the balcony area is to remove the insulation layer and expose the cement wall and then apply tiles.

2.Tile directly on the insulation. But there is a requirement to check the insulation process in your balcony.

Generally, it is the wall - the insulation layer - the galvanized mesh - the cement mortar - the coating. If the missing process is made up for galvanized mesh, the paint is removed, and then the tiles are pasted. It can be used with high-grade cement or directly with adhesives.

3.Slotted in the insulation layer and pasted with cement.

Some students are worried that the insulation layer and the wall adhesive strength is not enough, in fact, there is no need to worry, many of the buildings of developers are now insulated and then tiled on them. Because after the insulation layer is completed, the contractor should ask the construction to do a pulling experiment, the purpose is to prevent the strength from meeting the requirements.

Finally, TX who wants to follow the method of 2 or 3 must pay attention, this is the lesson of "blood". Generally, the size of the developer in the design of the closed balcony is designed according to the distance of the direct wall, so that sometimes it happens that the inward opening window on the side of the wall can barely be opened after adding the insulation layer, and then the tile can not be opened, closed or can not be carried out, then there is only crying, everyone must calculate well, if it is not suitable, simply shovel it off and then paste the brick.