-
You're talking about a thin layer on the outside. It's very simple, it's OK to use a hot towel, and that's how I got it when I installed it for someone else.
-
Cut with a blade along the junction of the membrane and the door, then divide into a part of the part, tear off.
-
Pour soapy water on the side and listen to others say it works!
-
Blow it with a thermoelectric hair dryer first, and it's good to tear.
-
Generally, it is easy to tear off, if it is difficult to tear, you can use a blow pipe to blow hair, blow hot air and try it.
1.The area is not large, you can use banana water to rise, and then wipe it with a cleaning ball and it will be gone. >>>More
There are many ways to do this:
1: The area is not large, you can use banana water to rise, and then wipe it with a cleaning ball. >>>More
You can find a place that is already a little up, and apply some wind oil essence (or other oily liquid objects) to the place where it is connected to the door, peel it a little more, and then peel it again, and so on several times, and then it will get better and better to peel, be patient! >>>More
If it is not good to tear, you can use a hair dryer to heat the side of the file to blow and tear!
Go buy a plasticizer and spray it, it will foam in ten minutes, it will be torn off, and then wipe it clean with water.