-
Anonymous users2024-01-24Outside the toilet tank, there is a nut for the threaded installation of the water inlet valve just below the water inlet valve of the tank.
You can remove the nut and you're good to go. Pay attention to drain the water in the water tank and close the water inlet when dismantling, so as not to get the water.
-
Anonymous users2024-01-231. Close the main water inlet valve in the room first. 2. Close the triangle valve under the toilet. 3. Remove the hose under the toilet. 4. Remove the plastic cap under the toilet tank.
5. In this way, you can take out the water inlet valve in the water tank.
The method of removing the water inlet switch of the toilet is very simple. The first thing is to turn off the water inlet switch under the toilet tank, then put the water in the toilet tank clean, then remove the snakeskin hose at the water inlet of the water tank, and unscrew the cap from the bottom of the water inlet pipe of the water tank, and you can take the water inlet pipe and accessories out of the water tank. The tool for disassembly can be disassembled with a wrench.
Clause.
1. Preparation for the installation of the flush toilet Before installing a flush toilet, the following 5 preparations should be made: first, check the level of the ground where the toilet is installed; The second point is to check the sewage pipe of the toilet bowl and remove the debris in the sewage pipe; The third is to leave a distance of 2 to 3 mm above the ground at the sewer outlet; The fourth point is to check whether there is any leakage in the water pipe and debug and install the water tank accessories. Finally, it is necessary to test the sewage effect of the toilet, if the water is flushed very quickly, it means that the drainage is not smooth and there is a blockage. >>>More
If there is a problem with the toilet, please find "Xitaotao" professional toilet accessories for repair. >>>More
You can only use the leather puff to suck, or use a professional dredging spring to dredge, I believe you don't have this thing, if the blockage is not bad, use the leather puff, if it is powerful, find a professional dredge phone in the corridor, call someone to help you, and the ultimate way, is to remove the toilet and then pass, is more troublesome.
Close the toilet inlet valve and make sure it's closed.
Disassemble the connection between the angle valve and the filter, and remove the filter part. >>>More