I use the Mercury 150M single antenna wireless router and I live on the fifth floor and put it on th

Updated on Balcony 2024-07-06
3 answers
  1. Anonymous users2024-01-24

    The WIFI signal is easily blocked by things, so there is no signal as soon as you enter the house, signal amplifiers, high-power wireless routers, wireless bridges, power line APs, and the above are all useful, but you have to choose according to the situation of your house.

  2. Anonymous users2024-01-23

    Add a wireless router to bridge the signal in a good location. After that, go into the house and take the network cable.

  3. Anonymous users2024-01-22

    dr1k7pf5dr1k7pf5

Related questions
2 answers2024-07-06

Buy a better router!

Press 2 routers! Bridge one in the bedroom. >>>More

2 answers2024-07-06

You can go and buy a penetrating strong one, instead of simply going far.

4 answers2024-07-06

The best use of TP-link is not as good as the built-in, you can buy the kind that is plugged directly into the motherboard Moreover, the bad signal is also related to the wireless signal transmitter, don't always work one side. >>>More

9 answers2024-07-06

This has little to do with 150M 300M, mainly depending on the power of your router antenna, the dbi value, the general router is 5dbi, this power cannot penetrate the reinforced concrete wall, can only rely on the reflected signal to accept, so that once there are more partition walls, the signal is very poor. There are 2 ways to do this without changing your layout, one is that you buy a wireless router with a high power antenna, and the other you buy a wireless power amplifier with an external gain antenna. Personally, I suggest that you change the layout, you can install a wireless AP on the ceiling at the door of your room as a signal amplification, as long as you connect the power supply, you don't need a network cable.