The bathroom is a cast in place roof, with a thickness of 10cm and a reinforcement of 14, which can

Updated on Bathroom 2024-07-06
1 answers
  1. Anonymous users2024-01-24

    If the sanitary partition wall is not on the beam, according to the requirements of the code, when there is no beam under the wall, put two reinforcing ribs at the bottom It is recommended that you put two 16 under the partition wall.

Related questions
4 answers2024-07-06

1.There are two medications to come.

Self-effective for centipedes, diluted solution of realgar water or dichlorvos after spraying on the floor and corners of the house, 2Closed for at least half a day, the effect is said to be good. Try to keep the bathroom as dry as possible. >>>More

5 answers2024-07-06

Toilet plumbing? First, we must pay attention to the slope of the inclined water in the bathroom to avoid the water not leaking to the ground, but accumulating at the door or even flowing into the living room, which is not fun. Personally, I think that when the bathroom pad is high, the waterproof beam must be done, and in the later stage, it should be noted that the position of the bathroom threshold stone must be increased by 2CM compared with the bathroom floor according to the specification. >>>More

5 answers2024-07-06

1。It depends on the quality of the exhaust fan you use, as well as the power, air volume and other parameters, if the parameters are small, you can change to a larger one. >>>More

2 answers2024-07-06

From the perspective of professional construction, it should be added, but now it is relatively small.

1 answers2024-07-06

If you talk about an integrated ceiling, it should be an aluminum panel, not an aluminum-plastic panel. If you want to disassemble the integrated ceiling, insert a flathead screwdriver into the gap of the small board and pull down hard to remove one piece, and then take the second one.