1 answers
-
Anonymous users2024-01-24Shown is the clamping force in kiloN.
In fact, the structure of this table is a pressure gauge, but the clamping force at the center of the display dial is calculated by multiplying the pressure of the hydraulic system by the area of the cylinder piston.
Related questions
2 answers2024-07-03
Hello! Lathe tailstock.
Lathe tailstock >>>More
3 answers2024-07-03
The lathe tailstock pressure plate can not be used iron plate, this is a strict requirement.
2 answers2024-07-03
Hello! Does it refer to the transmission principle of the tailstock sleeve? >>>More
3 answers2024-07-03
The taper of the tailstock cone of the C6140 lathe is: 1:, that is, the Morse taper 4 >>>More
2 answers2024-07-03
The problem is too general, and the side effect of the screw is force transmission. >>>More