-
Anonymous users2024-01-24Modern home has higher and higher requirements for bathroom facilities, many families want to have an independent bathing space, but due to the limited sanitary space, it is envisaged to put the bathing facilities in the corner of the bedroom, forming a relatively independent bathing space, reasonable use of bedroom space, and convenient for normal life, is a very feasible program.
It is difficult to install a shower room in the bedroom, the most important thing is to solve the drainage and ventilation problems of the shower room, and the following points should be noted;
1. The corner of the shower room in the bedroom is best close to the kitchen and bathroom room with drainage pipes;
2. Make a foundation of a few centimeters high according to the plane size of the shower room, pre-bury the drainage pipe of the shower room in the foundation and connect it to the drainage main of the kitchen and bathroom through the partition wall, and do the corresponding waterproofing.
3. Penetrate the wall in a suitable position and connect the ventilation pipe to the outdoor or to the ventilation pipe between the kitchen and bathroom.
4. Customize a better shower room according to the size.
-
Anonymous users2024-01-23Groove removal on the ground, hole in the wall, installation of drainage pipes, may only be able to install a maximum of 32 large pipes, and the groove can be removed from 40 to 50. No matter how big it is, it can't pass the floor steel bar. All the way down to the toilet drain or the nearest floor drain.
This slope is basically impossible to find, you have to raise the entrance of the bedroom a little higher.
-
Anonymous users2024-01-22If there is no drainage pipe in the bedroom, it is best to find a designer to design it, the first layout is more reasonable than yourself, and the second is more beautiful.
-
Anonymous users2024-01-21The sewer will be connected to the main sewer pipe of this floor, and the drainage of the flat floor must have a slope, depending on whether the shower room you want to install meets the drainage requirements.
Why do you want to install it in the bedroom? There is nothing else in the countryside, but there are many places, in fact, it is completely possible to build an independent small space. >>>More
Look at the thickness of the glass, the thickness of the stainless steel, the hardware (track), pay attention to the location of the floor drain when decorating, and the slope should be left well.
Because you are renting a house abroad, it is best to ask"Landlord"Report. Don't do it yourself. If"Backup", available at"Domestic"Buy. >>>More
The installation of shower rooms in many factories may be different, but the general direction is the same, first of all, prepare the tools to be used: screwdriver, impact drill, electric drill, air batch, rubber hammer, glass glue, glass gun, positioning level, tape measure, etc. The steps are as follows: 1, install the aluminum on the following and the left and right sides, install the fixed glass, and then install the aluminum on the top, fix the screws, 2, and then move the shower room and put it on the bottom stone, and then install the aluminum on the wall, mark it on the wall, and then lift the shower room to one side and put it against the wall 3, do a good job of positioning it with a level, and then fix the aluminum on the wall, and then lift the shower room up and install it, and fix the aluminum on the left and right sides and the aluminum on the wall. Then install the pulley on the movable glass, hang it on the aluminum material and fix it, then adjust the movable screws of the upper and lower sliding wheels, adjust the high bottom, and make it firmly fixed in the slippery water of the upper and lower aluminum. >>>More
It is recommended not to install it directly above the shower room, it will be very hot on the head, and the AIA dry and wet zonal heating system I installed is a little more convenient, you can adjust the temperature by yourself, and it will automatically cool down if it is high.