-
Anonymous users2024-01-24Yes, I just changed it a few years ago, buy a heart 25, the outside of the connecting pipe (less than 1 meter) 15 yuan, the maintenance worker door-to-door fee of 50 yuan (my toilet is out of warranty), if your toilet is in the warranty period, you can find the brand after-sales service repair (ask if the charge is not, if you charge, how much).
-
Anonymous users2024-01-23The basic steps are as follows:
Remove the plug left by the plumber during installation, wrap raw tape around the ball valve, and go up to the water inlet pipe on the wall. so that the water can be switched on and off.
Open the water tank and take out the water connection pipe of the water tank.
Measure the size of the hanging hole of the water tank, use an electric drill to punch holes in the wall, put on the screws after drilling, and fix the pipe for hanging the water tank.
The water tank is on the wall with good screws, hang it up, and the lower side is on the sewer pipe, after installation, use a plum screwdriver to tighten the screws, and the water tank will be fixed.
Then put one end of the hose on the ball valve and one end on the bottom of the water tank to connect the inlet pipe. The tank is basically installed.
Finally, at the connection between the water tank sewer pipe and the toilet on the ground, glass glue is put on to prevent water leakage, and the ball valve is opened to release water into the water tank.
This has to analyze the specific situation, if you buy a water tank that has not been used for a long time and is of a higher grade, you should change the socks to open the attack. Otherwise, it is better to change the water tank to the beat ignition gear.
It is still recommended to use natural water storage.
1. When we buy a new squatting toilet, after the master installs it, we find that the flushing tank of the squatting toilet is too small, we must find the reason in time, first check whether it is the reason for the squatting toilet itself, it causes the flushing tank of the squatting toilet to be too small, if not, find the answer to the question of the early hole in the installation one by one. >>>More
1. The float cargo float of the inlet valve is stuck, and the float (float) can be pulled up and down by hand, and it can move up and down smoothly under normal circumstances. >>>More
It is often left uncleaned, especially in summer, which is a good place for microorganisms to multiply.