How to solve the problem that the flush tank in the bathroom is too small

1. When we buy a new squatting toilet, after the master installs it, we find that the flushing tank of the squatting toilet is too small, we must find the reason in time, first check whether it is the reason for the squatting toilet itself, it causes the flushing tank of the squatting toilet to be too small, if not, find the answer to the question of the early hole in the installation one by one.

2. When the flushing water of the squatting toilet flushing tank is too small, first check whether the water level of the squatting toilet water tank is too low and the amount of water is too small; The water level of the inlet valve can be moderately raised to a suitable position to alleviate the small flushing of the squatting toilet flush tank.

If the situation does not improve, you need to continue the investigation, first check whether the water tank drain outlet is blocked by other components or the key lever is too short, so that the water drains slowly and less.

3. Check whether there is something blocked or blocked in the sewer pipe, there are bends, etc., resulting in poor water flow, if so, adjust it appropriately according to the actual geographical environment.

4. Check whether the switch of the water inlet angle valve is suitable and whether it can be fully opened, and the water volume in public places with large flow of people cannot be filled within 2 minutes, and the angle valve can be fully opened.

4. It is necessary to focus on the dry meaning of the squatting toilet flushing tank, when opening the opening and lifting, we must pay attention to the place where the elbow is connected with the squatting toilet, and the installation position must be appropriate, otherwise it is easy to block, resulting in the drainage valve is not smooth.

The toilet flush is not enough, and the toilet is not flushed clean, which may be a problem with the toilet shifter, that is, the water outlet of the toilet is not directly facing the sewer pipe, and there is a curve in the middle, which is connected when the toilet is installed. It is also possible that the toilet is blocked, after the toilet is blocked, when flushing, the water level will slowly rise, and the toilet will not be flushed. It is also possible that when you use it, you don't have a good reason to do it, and you don't let go when you press the flush button, which will also cause the impulse to be insufficient, and you must press it for 2-3 seconds, so that you can completely open the flush valve, and the flushing effect can be the best.

The water tank is not enough, the inlet valve stops the water in advance, or it is not adjusted properly.

2.The tank fittings are out of order. For example, the drain valve is not well adjusted, or the quality is problematic, and the water is sealed in advance.

3.Blockage in places such as flush pipes or squatting toilet interfaces.

1. The height of the float in the squatting toilet tank is relatively low, resulting in a relatively small amount of water in the water tank 2. The water outlet of the squatting toilet tank is blocked by foreign objects.

3. The water valve switch installed on the squatting toilet is relatively small, or the cable is relatively long4. When the squatting toilet is installed, the rubber sealing sleeve inside the squatting toilet is too tight, resulting in a relatively small flow of water at the water outlet.

Question: The squatting toilet has a small impulse, and it is still the same that cannot be flushed clean after changing a few water tanks, and what is a good solution if the squatting toilet is not replaced.

Asked about the problem of the water tank, I found a special person to debug it, and said that the water tank was no problem, and the water tank was installed by professionals.

Question: I've tried all of what you said, and said it was a problem with the squatting toilet.

It may be that it does not meet your standards, or your standards are too high, as long as you can rush down.

Question: Only change the water tank, but the squatting toilet can't be changed.

I can't move at all.

Then you're basically a problem with the installation of the squatting urinal.

No problem with the water tank.