There is a watermark on the wall outside the bathroom door about the height of a half baseboard, I d

Updated on Bathroom 2024-07-26
2 answers
  1. Anonymous users2024-01-24

    A week is enough to dry, it should be determined that the bathroom is caused by the water turned outward, because the waterproof in the bathroom is generally 15cm to 20cm high, but you stick the floor tile is probably only less than 10cm high, if the pipe has internal leakage, or the corner of the wall waterproof damage, it may be that the water goes up the wall, but the bathroom is the tile water can not come out, only up or out, so the outside wall is revealed, in order to must first treat the waterproof and then deal with the outside wall, if the inside is not dry, the latex paint will be pulverized, If the door is a suit door, it will also cause peeling and warping.

  2. Anonymous users2024-01-23

    First make sure that the bathroom wall has been drenched? If the wall has not been drenched with water, then there is a watermark on the wall, and it is generally the ground that has water seeped into the wall. After the ground construction is completed, it generally needs to be maintained, and there is also water vapor for the floor tiles, if it is a small part, it should be no problem, the wall is more normal, and it will be good after a while, the problem is not big, and the windows need to be opened for ventilation.

Related questions
1 answers2024-07-26

In most cases, there may be water seepage, so you'd better take a picture and I'll give you an exact answer.

1 answers2024-07-26

Bathroom for a brick does not need to do waterproof, but you change the brick process will be difficult to avoid the destruction of the waterproof layer, you must be careful, you take off the brick, the following brick layer has been hard, if you want to paste a new brick must shave off the brick layer, at this time waterproof is very easy to destroy, it is recommended that you change the brick do not shave the brick layer that has solidified below, to the building materials market to see if there is that kind of thin adhesive brick glue, be sure to scrape the brick under the glue, to prevent water seepage from the periphery of the brick in the future. Finally, the bricks are caulked around and must be embedded.

3 answers2024-07-26

The color of this contrast is not very good at home.

2 answers2024-07-26

There's a heating pipe or hot water pipe connection underneath.

1 answers2024-07-26

How to deal with a broken bathroom floor tileYou can pry off the broken floor tiles, clean up the original mortar, and then fill it with floor tiles. . . >>>More