-
Anonymous users2024-01-24Let me explain it to you!
The sliding table saw has two saw blades, a large main saw blade, a small guide saw blade, the saw plate without paint finish is generally only used with a main saw blade, only the saw plate with a finish is used to guide the small saw blade on the reverse side of the plate to do slotting guidance, so that the paint finish of the plate will not burst the edge, in addition to the sliding table saw can also be fine-cut board, in the jargon is to open wool and concentrate.
Precision saws belong to larger equipment, this kind of saw is generally used in factories, this is because a large number of materials can be used, some have a guide saw blade, and some are not, no guide saw blade will burst the edge.
As for the edge of the plate that is cut out of the ordinary saw, it is not recommended that you use the trimming machine to trim the edge, the trimming machine is only suitable for scattered use, and it is only better for special-shaped parts to be used, and the parts need to put wool to trim the edge with the trimming machine, if it is mass-produced, the trimming machine will increase the production and material cost a lot.
Now the most practical thing for you is the sliding table saw.
There is still a market for panel furniture, the cost is low, if you want to do it, you still have to look at the local situation!
-
Anonymous users2024-01-23.Burst edges. Two reasons. /.One is that the plate is not good, and the other is machinery and equipment. Or the saw blade is not good.
-
Anonymous users2024-01-22First of all, what kind of board do you use? What kind of paper is pasted on the board? If the hollow core slab is recommended to use an automatic panel saw, the sawing edge is straight and not easy to chip.
Personally, I think that the particleboard pasted with melamine-impregnated paper is the easiest to collapse, in case the particleboard material is not good, it is simply a dead man! According to your plate material, choose the right number of teeth of the saw blade, it is easy to understand between the general peers, and then adjust the groove saw and the main saw in the same straight line, the groove saw should be wider than the main saw saw road width or so, if your groove saw is a single trapezoidal saw, up and down left and right to adjust and then do, if it is a double-piece combination saw, the placement of the gasket must be reasonable. The pressure beam pressure of the automatic panel saw is insufficient, and the slight running of the plate will also cause the collapse of the edge, the right side of the table of the push table saw and the main saw blade must be parallel, and the discharge port should be slightly larger than the feed port, so that the plate will not be scraped by the end of the main saw to cause artificial collapse, and if the slide rail of the push table saw is worn more severely, the plate can not be processed in a straight line, and the collapse is inevitable.
Reduce the cutting speed.
Reduced to no collapse. >>>More
1. It's best to inspect a few more, choose a powerful manufacturer to order, don't be in a hurry to communicate with the phone a few times to order.
Technical strength: check whether the manufacturer really has its own independent R & D personnel. Whether the machine was developed in-house or imitated. >>>More
I remember watching carpenters make furniture in my hometown, whether it was a cook or a cabinet, all the templates were made by the carpenter by hand. The current panel furniture materials are made by the cutting machine, and the surface of the board made by the cutting machine is smoother, and there will be no error in the size. But there are also some panel furniture cutting machine out of the board chipping, what is the reason for this? >>>More
Jinan production engraving machine manufacturers less than two or three hundred, large manufacturers and big brands to Jinan Gete, Jinan local users, standardized production, large output, can go to Jinan furniture factory to see the actual processing effect.