-
Anonymous users2024-01-24There are two reasons: 1 When installing the toilet, there is a sealant called the flange ring that is displaced, and a small amount of dirty water does not enter the drain after convenience, and the water will stink as soon as it dries. It will come out of the two small holes with a diameter of two centimeters on either side of the toilet or at the back of the toilet.
100% has two small holes. 2 There is a crack in the glass around it. Cut off the old glue.
It's okay to replay it once. The first reason solution is to change the flange ring. 10 20 yuan or so, change and then seal the glue.
That's it. I am a professional installation and sanitary ware maintenance personnel.
-
Anonymous users2024-01-23When installing the toilet, there is a sealant called the flange ring that is displaced, and a small amount of dirty water does not enter the drain pipe after convenience, and the water will stink as soon as it dries. It will come out of the two small holes with a diameter of two centimeters on either side of the toilet or at the back of the toilet. 100% has two small holes.
2.There was a gap in the surrounding glass. Cut off the old glue.
It's okay to replay it once. The first reason solution is to change the flange ring. 10 20 yuan or so, change and then seal the glue.
That's it. I am a professional installation and sanitary ware maintenance personnel.
-
Anonymous users2024-01-22No, if there is a lot of glass glue, you can cut it with a knife, as long as it is not sealed, it is beautiful.
-
Anonymous users2024-01-21On the 2nd floor, it's best to find a professional to see what's going on inside.
Natural aging, that's okay. If it doesn't turn black, it's a good glass glue. A lot of glass glue will turn black after too long. Pay attention to when choosing glass glue.
You first wipe the leak with water, then apply glass glue, let the toilet be disabled for eight hours, and then try again.
The curing of glass glue not only requires a certain temperature but also an oxidation process, generally the surface cures for 4 hours, and it takes 24 hours for complete curing, so heating and roasting with a bath bomb bulb cannot accelerate the curing (unless the room temperature is lower than 10 degrees). >>>More
Generally, the water in the room is alkaline, so just like the friend said above, remove the current glue and then re-glue.
Yuan hazel mildew remover can remove black mold on the glass glue, spray directly on the surface of the glass glue, or brush with a brush! After removing mildew, it will prevent mildew, and at the same time, it is equipped with deodorant to remove polluted odors!