-
Anonymous users2024-01-24This is caused by the water pressure in your home being too high or too low, and the way to deal with it is very simple.
1. When not in use, you can close the inlet valve of the water heater.
Second, a check valve can be installed at the water inlet of the water heater, and the check valve is sold in general hardware stores. Of course, the quality is good and bad, you can choose by yourself.
-
Anonymous users2024-01-23Hello, thank you for asking the company.
After the toilet stops filling water, due to the large water pressure, the water flow in the pipeline backflow hits the water flow sensor of the gas water heater, and the machine detects the water flow signal and starts it, and the fan will rotate for dozens of seconds. It is recommended to close the inlet valve of the water heater and it will not be there.
You are welcome to ask the company questions again.
We wish you a happy work life
-
Anonymous users2024-01-22The machine is defective:
It's that the water flow starter of your water heater is too sensitive. If the water pressure in your home changes slightly (such as the moment when the toilet is filled with water), the backflush water pressure generated in the water pipe will impact the water flow of the water heater to start the sensing device, and the water flow start sensing device will generate an instantaneous start signal to the main controller, and the machine will automatically start and of course the fan will turn.
When you don't use the machine at home, turn off the water valve on the water inlet pipeline, and this problem will not occur!
Now there are also good starting devices, such as the water heater produced by "Shanghai Shenhua" uses a vortex rotor pulse water flow sensor, so this failure will not occur.
-
Anonymous users2024-01-21This depends on how your waterway is connected, if the installer connects the inlet of your toilet tank with the outlet of the water heater, there is this possibility, every time after flushing, the toilet will enter the water, and the water heater will work when the water is in, so this will also happen.
-
Anonymous users2024-01-20It doesn't sound like much of a connection, could it be a coincidence?
Clean the water tank of the toilet, the water over the sink will not be a problem.
You can change the inlet valve, go to the nearby store that sells toilets, water tank accessories stores or building materials stores to take a look and ask to buy one, the water inlet valve can be divided: float type inlet valve (about 10 yuan), lifting water inlet valve (about 15 yuan), the lifting water inlet valve is better, the water level of the water tank can be adjusted, and it will not affect the drainage valve. When removing the original inlet valve, remove the iron nut of a hose connected to the outside of the water tank with the plate head, and then remove the plastic nut at the bottom of the outside of the water tank (not at the bottom of the water), and the new inlet valve can be installed according to the original method, which is very convenient.
There are three scenarios for a leaky toilet:
1. The water leakage at the water inlet of the water tank, the water leaks to the toilet, the solution is to remove it to see if the rubber pad has been damaged, if no harm is found, you can try to change the direction of the rubber pad to install it. If it doesn't work, then you can only replace the rubber pad; >>>More
Hello: The situation you are talking about is that the flush valve in your home is broken, or it may be blocked by impurities, you can try to twist it by hand, move it slightly from side to side, if not, you can ask the master to help get it down, the price of the water piece (flush valve) is generally between 30-50! If you have the tools, you can replace them yourself. >>>More
What should I do if the toilet tank keeps getting water and can't stop.