-
Anonymous users2024-01-24The toilet water test is also called the water storage test, which should be filled with water and the water should have a sufficient volume. The water storage depth of the water storage test should not be less than 20mm, the water storage height is generally 30-100mm, the water storage time is 24 hours, and the water surface has no obvious drop to be qualified. Generally, this test is done on the roof, bathroom or room with waterproof requirements, and the early stage of the water storage test should be checked downstairs every 1 hour, and the later stage should be checked downstairs every 2-3 hours.
If water leakage is found, the water storage test should be stopped immediately, the waterproof layer should be re-improved, and the water storage test should be carried out after the treatment is qualified.
When testing the water in the bathroom, do not leave the house in advance, and close the faucet and room water valve in time when the water is stored enough to avoid accidents and unnecessary losses.
-
Anonymous users2024-01-23Answer: Hello, be sure to do a water experiment. After the construction of the toilet is completed, all the drains of the toilet are blocked, and a 25cm high "barrier" is built at the door"Then fill the toilet with water at a height of 20 cm and check the surrounding walls and floors for leaks after 24 hours. This 24-hour water test experiment is the key to ensuring the quality of the toilet waterproof construction project, although it is troublesome, but it must be done.
-
Anonymous users2024-01-22In fact, the waterproof layer of the bathroom, if according to the current practice (i.e., a layer of rigidity, a layer of flexibility, operation specifications, serious. There is no need to do any experimentation at all.
Even if the closed water test is done, if the process does not meet the requirements, there is no problem at that time, and I dare not say that it will be no problem in the future.
This kind of situation where the ceiling has been made downstairs should be done carefully according to the standard.
-
Anonymous users2024-01-21Generally, the water leakage is around the pipe, or at the corner of yin and yang, and you can observe the situation downstairs.
-
Anonymous users2024-01-20Let's see if there's less water, isn't it?
-
Anonymous users2024-01-19It's not easy, you plug the toilet toilet.
If the water seeps down, it will definitely not work.
That has nothing to do with you, it's the leakage of the part under your waterproofing, the loose and leaky big pipe under the toilet, it has nothing to do with you, you should go to the property or contact the property for maintenance, the responsibility of the developer.
Testing the water in the downstairs bathroom does not affect you anything, and even if there is infiltration in the bathroom testing the water, it may only be the moisture on the wall, not like rain, so there is nothing to worry about.
There is no strict requirement for the height of the water test, cover the mouth of the sewer pipe, and it is almost two centimeters above the ground. Keep it for 24 hours, and see that the top surface of the downstairs is not leaky. ，
Acceptance criteria: After 24 hours of filling with water, check that there is no leakage at the bottom of the board, that is, this is qualified! This is known as the "closed water test".
Let's do it again, it's already seeping. In this way, it will still leak after living in, and it will be more troublesome when it is repaired in the future. If you are in Guangxi, you can also find Yutuo Waterproof to help you take a look.