Bathroom water heater hot water pipe leakage to the downstairs residents, how to repair

Updated on Bathroom 2024-07-15
4 answers
  1. Anonymous users2024-01-24

    Find a local dealer and after-sales maintenance personnel to repair it.

  2. Anonymous users2024-01-23

    Find a water heater dealer to fix it.

  3. Anonymous users2024-01-22

    1. First of all, determine where the water leakage point is;

    2. Simple water heater water pipe leakage: buy a strip of anti-seepage cloth to wrap up the leakage, or use adhesive tape to seal it, and then try, there is no problem. But if it doesn't work, then you need to hire a professional to repair it.

    3. If it is an interface, you need to determine where the interface is;

    4. Water heater water valve or connection leakage: If you find that the connection of the water heater is leaking, especially the water valve, or there is a leakage at the connection, if you want to think about whether the water pipe interface is loose, then you only need to tighten it. And if it can't be twisted, then use raw tape to wrap it, and stick it with adhesive tape.

    5. Leakage of the connection between the hot water pipe, the water tank pipe and the water tank: if you can't find the place where the water leakage is, then you need to conduct a detailed inspection of all parts of the water pipe, from the pipe of the water heater outlet to the water tank pipe, interface and other parts are inspected in detail.

    Non-professionals are advised to make an appointment with a professional maintenance master for on-site inspection and treatment.

  4. Anonymous users2024-01-21

    This has to find a local dealer to repair it, and the property bureau will take a look.

Related questions
3 answers2024-07-15

If the water supply pipe is blocked, there is no way to unblock the pipe. You can only replace the pipes, and don't trust other methods.

4 answers2024-07-15

Since there is no buried hot water pipe, only open pipes can be installed, which is a little ugly.

1 answers2024-07-15

If the pressure is sufficient, the pressure of the water heater is mainly the pressure of the inlet pipe, and it is not a big problem which way to go. If the water outlet pressure is small, a booster pump can be installed.

1 answers2024-07-15

To be sure, you didn't connect the ground wire; All electric water heaters must be connected to the ground wire and anti-leakage switch. >>>More

2 answers2024-07-15

Unless you add a pump in the middle of the line!

It is recommended to place a bucket in the bathroom to drain the cold water into the bucket, which can be used to flush the toilet or mop the floor. In fact, it looks like the pipeline is quite long, and it doesn't really drain so much into the bucket. >>>More