How to adjust the amount of water in the toilet

Adjustment of the size of the water discharge:

1. Adjust the water level of the water tank and adjust the water inlet valve. As shown in the figure above, fine-tune the screw rod, adjust the up and down position of the float, the red direction, and adjust to the low water level; In the blue direction, turn to the high water level. Of course, there are many local methods that can also achieve similar effects, such as throwing bricks into the water tank, water bottles, etc. >>>More

You have to open the toilet lid, and then there will be a water level adjustment switch in it, and you can adjust it upwards. That is, a float switch, after the amount of water reached, it will turn off and enter the water.

1. Adjust the connecting rod.

Open the toilet tank, you can see the black column on the tank, this is the toilet connecting rod, mainly to adjust the toilet button. For better use, it is recommended that the connecting rod should not be too long, as long as it is in contact with the blue and yellow two small pieces under the water tank. During the adjustment process, it is recommended to make the connecting rod one short and one long, and the flushing volume of the toilet will be more moderate. >>>More

The manual twist flush valve does not have water volume adjustment, it is recommended that there are two methods, the simple is to adjust the bathroom water inlet valve to reduce the water pressure and water volume, and the complex point is to add a rubber pad at the connection between the flush valve and the water inlet pipe, and open the hole in the middle according to your needs to control the water intake. Hope to adopt.

There is a flush float in the toilet, and the amount of water produced by adjusting the height of the aconite can be adjusted.