How to adjust the water volume of the toilet in Bejas?

1. Adjust the connecting rod.

Open the toilet tank, you can see the black column on the tank, this is the toilet connecting rod, mainly to adjust the toilet button. For better use, it is recommended that the connecting rod should not be too long, as long as it is in contact with the blue and yellow two small pieces under the water tank. During the adjustment process, it is recommended to make the connecting rod one short and one long, and the flushing volume of the toilet will be more moderate. >>>More

There is a flush float in the toilet, and the amount of water produced by adjusting the height of the aconite can be adjusted.

Open the lid of the toilet tank, and you will see a cross notch at the top of the float valve, turn this notch to the left with a change cone, and the water level will be lowered, and turn to the right, and the water level will be raised.

Open the upper lid of the toilet, there are two buttons on the lid of the water tank, one is a small amount of water, the other is a large amount of water, the water tank of the toilet is generally a general rule is less up and down more, if you want the water output of full drainage and semi-drainage is the largest, just adjust the two buttons to the bottom, and the full drainage should be adjusted to the bottom, because the full drainage is generally used to flush the stool, and the larger the amount of water, the better. Semi-draining is used for urinating, and generally does not need to use a large amount of water, so it is appropriate to adjust it to the middle position.

First of all, we must know that the adjustment of the total water inlet of the water tank is the height of the float on the left inlet valve. Then you should ask the question of the displacement of the drain valve, first of all, you must recognize the role of the two movable adjustment joints on the drain valve, as shown in the following figure >>>More