After a few days of toilet sitting at home, I found that the water was leaking, how can I make up fo

The reason is this, the toilet is not installed with the mouth of the sewer pipe, resulting in drowning, the general toilet is used to connect the tile with glass glue, in fact, this is not correct, glass glue is not only not waterproof, it is easy to expand, shrink and denature when exposed to water. Reinstall it, make a heightened circle around the sewer pipe with waterproof products, slightly higher than the floor tile and larger than the toilet mouth, and then align and install it, and plug it around the toilet with a plugging and impermeable product.

If the toilet has been installed, you can also put a plugging and impermeable product around the edge of the toilet.

You can go to the Internet to buy a kind of plastic steel mud (AB soil). It is an alternative to glass glue. It hardens completely after about 20 hours. It works well.

If you can't find it, I can go straight to me.

Is it not according to the flange, go to the building materials city to buy one, it is very cheap, and you can get it for a few dollars.

1 is the problem of installation, there is no installation of a closed water circle!

2. The outlet and drain are good for each pair.

It's a matter of installation, and there is no airtight closed water circle!

The toilet is installed with a special sealing ring, also called"Butter rings", there are some sanitary ware stores that sell them.

The function is to prevent the bottom of the toilet from leaking!