-
Anonymous users2024-01-24Usually there is a small clip in the louver space around such a louver, you can look for it, and then you can remove it with a dial. Hope it helps, don't pry too hard.
On both sides is a spring card, you can cancel it by deducting it down, if you just change the lamp tube, you can see the place where there is PRESS on the lampshade, press the transparent lampshade outside and it opens, I open the lamp shop, you can ask me if you have any questions.
It was the iron chassis that had moisture and rust. Knock on the bottom edge of the iron with the handle of the screwdriver and try again. It is necessary to replace the shunt switch in the lamp, which should not be easy to repair, and the small plastic shell.
Remove the entire bath bomb.
Remove the ceiling on one side, the bath bomb is not directly stuffed in, and there are screws hanging around it. >>>More
<> should first cut off the power supply (neutral line and phase wire), and when it is confirmed that there is no power, take off the light bulbs in the bath bomb one by one and wipe them with a cloth stained with a small amount of neutral detergent. >>>More
This ceiling is an integrated ceiling with a keel inside, and the canopy light is stuck on. You can remove the gusset on the side, grab the frame of the ceiling lamp with your hand and pull it down, and you can take the ceiling lamp down. >>>More