-
Anonymous users2024-01-24The bath bomb is generally installed on the keel, and below is a bath bomb panel, which is buckled on the keel like the ceiling gusset, and can be removed by prying it from a corner with a wallpaper blade, and the panel can be replaced by removing it.
-
Anonymous users2024-01-23Don't think about it, there is a top plate around the lamp that can be removed, and then the whole lamp can be removed.
-
Anonymous users2024-01-22Hello! You are an appliance that integrates ceiling lighting and heating. You can see that there are more than two spring buckles on each side of the lampshade, and you can move all the buckles to remove the lamp as a whole.
How to remove the gusset: use two harder plastic cards, insert the corners of the gusset, move the card to the other end, pry a little hard down to make a little gap, and pull out the gusset by hand. (Just like opening a door lock with a plastic sheet).
Take a photo with your mobile phone, go to the store that sells the lights and ask them to see, say that the lights are not on, ask if there is a lamp to change, if there is, ask him to take a sample to show you, OK, if the store is near, you can ask him to help you change it.
How about the replacement steps of the bathroom ceiling lamp Before changing the lamp, you should first disconnect the power supply, this is a very important safety protection, you don't think that just changing a lamp, there will not be much problem, but often the problem appears in this idea. Then, after turning off the power, we need to check what the problem is, whether it is a broken bulb or a bad wiring contact of our lamp. After checking the problem, it is the last step If the bulb is broken, then you need to remove the lampshade and replace it with a new one. >>>More
This should be from the top of the top can be opened for the replacement of the lamp.
Grasp the square part in the middle, loosen it slightly up and down before and after, and then pull it down, which is connected and fixed by four small sockets, which is not very good for a long time, a little skillful. >>>More
First cut off the power supply, use the suction cup (the kind of hook on the tile, made of rubber) to suck the electrical panel, and take off the electrical panel (the suction position should be cautious and the action should be light). Then pull the lamp buckle away, unplug the lamp, replace the lamp, buckle the button, and cover the panel. Replace the lamp with the original ballast. >>>More