-
Anonymous users2024-01-24I think there's only one explanation.,That is, when you go to bed at noon.,That part should be covered more tightly.,It's a little hot.,Remind yourself to change the temperature.。。
-
Anonymous users2024-01-23You're on the toilet and your sister is talking to you on the sidelines? Dreams, hehe, fake,
Generally, the phenomenon that the water has been flowing non-stop after flushing is the rubber plug cover of the outlet or the mouth has scale, you open the water tank cover, and then find the outlet that is the outlet where the water from the water tank flows to the toilet, and check the rubber cover on it to see if there is scale or wear. Generally, it is because of the poor sealing that it causes long-term running water.
With the development of society now, many things have gradually appeared in our lives, enriching our lives. The flushing toilet is a kind of furniture that is used more frequently now, and it is also relatively convenient to use. But sometimes the toilet will also break, such as the toilet flushes automatically, so it will be a waste of water, and many friends don't know what to do. >>>More
According to what you said, it is most likely not "poor pumping", but "poor drainage" and "poor drainage". Because: "the water in the tank can be drained at one time" means that the pumping is normal, and if the pumping is not clean, it cannot be discharged, the drainage is slow, and there are many dirty things, which cannot be washed away. >>>More
How do you unclog a flush toilet? Toilet blockage is generally a blockage at the toilet trap, and the best and easiest way is... >>>More
1. Before the installation of the toilet, check whether there is sediment, debris and other blockages in the sewage pipeline, whether the installation surface is level 2, determine the sewage pipe and draw a cross line 3, determine the sewage outlet of the toilet and draw a cross line 4, determine the installation position at the bottom of the toilet with an electric drill and bury the expansion screw 5, install a special sealing ring (i.e., steamed wax orchid or rubber orchid) at the sewage outlet of the toilet or circle glass glue (putty) or cement slurry cement and sand ratio 1:3 6. The toilet crosshairs and the surface crosshairs are quasi-consistent, and the bottom of the toilet is circled, glass, glue (putty) or cement mortar, cement and sand ratio: 1:3, and the toilet installation should be kept horizontal; 7. Tighten the screws for the installation holes of the toilets; 8. Install and debug the water tank accessories, install and connect the water source, check whether the water inlet valve is inlet and sealed, check whether the drain valve and the installation position should be installed closely, whether the leakage check whether the button is closed, whether the chain is short, whether it is appropriate, whether the machine is jammed, check the leakage, install the water inlet valve filter device 9, If you find any differences in the trial process of adjusting the toilet, please refer to the toilet tank accessories to see the fault and treatment, check and deal with 10, the toilet installation should wait for the glass glue (putty) or cement slurry to solidify and discharge water, and use the curing room 24